USB BUB III Assembled BUB III:assembled BUB III Feedback on the design and

Feedback on the design and the development environment continues to be welcome via the Forum

The innovative RFM95W / RFM96W radio transceiver modules by HopeRF build on the strengths of the RFM69 series by adding support for the LoRa™ PHY modulation method

This version was announced in this Weblog and assembly described here and here

you can select this option - just add the C2/C3 decoupling capacitors and a 14 pin footprint module such as the  RFM69CW

3V is used for interconnection

USB BUB III Assembled BUB III:assembled BUB III Feedback on the design andJeenode Zero ready: The USB BUB III board is a flexible active USB connector. It uses a branded FT231X chip to convert USB traffic to serial, including important control signals. It appears as a virtual "COM" port when hooked up to a PC USB port. If youre looking for the BUB II its here The board's highlights: The USB BUB III is fully assembled and tested. Connect up and it's ready to go. RTS DTR reset control customised for many ARM series MCU's such