RFM95W / RFM96W Radio LoRa : An antenna must be

: An antenna must be connected to the module - extended operation without a matching antenna at the higher transmitter power levels risks permanent damage to the RF module output stages

You can connect the Flash Board to the target board ISP header or  ZIF socket with multiple jumpers (take care to match the pins)

chose the JeeLink 868 NoCase option - this is supplied without the clear plastic case

and a few other components to create a working JeeNode SMD

See this page for an overview of the numerous combinations possible with the Carrier Board

RFM95W / RFM96W Radio LoRa : An antenna must beLoRa is here! The innovative RFM95W RFM96W radio transceiver modules by HopeRF build on the strengths of the RFM69 series by adding support for the LoRa PHY modulation method. This spread spectrum technique can communicate even when signals are buried in the background noise, providing long range, with high interference immunity at an adequate bit error rate. Typically there is no need to blast out at the full +20dBm transmit power available,