Europa Tools Carbide End Mill 2 Flute Square Edge - Long Length - Pulsar DMX - 6mm x 20mm Standard 36 mm nominal diameter

36 mm nominal diameter

Orientation cue: Distinct red indexing band aids quick orientation during setup and inspection

this reamer combines a left-hand spiral flute and right-hand cutting for efficient chip evacuation and a clean

helping maintain tight tolerances during extended use

and workshops that demand consistent results from their hole finishing tools

Europa Tools Carbide End Mill 2 Flute Square Edge - Long Length - Pulsar DMX - 6mm x 20mm Standard 36 mm nominal diameterThe Europa Tools Pulsar DMX 2 Flute Carbide End Mill is built for deep reach milling in hard metals, delivering precise square edge cuts and extended reach for challenging pockets and slots. With a 6 mm diameter and 20 mm cutting length, this long length end mill handles demanding pre hardened steels up to HRc55 with confidence. Diameter: 6 mm Length of Cut: 20 mm Overall Length: Long length design for deep reaching milling tasks Flutes: 2 flute